Supplier Quality Engineer (CMM)

Role:

The Supplier Quality Engineer (CMM Focus) is responsible for CMM programming, metrology validation, and supplier quality assurance to ensure that parts supplied meet engineering drawings, GD&T standards, and quality requirements. The role supports incoming quality, supplier qualification, audits, failure analysis, and continuous supplier improvement, with strong involvement in SMT and mechanical components.

This position is based in Pasir Gudang, Johor Bahru, Malaysia.

Responsibilities:

CMM & Metrology

• Develop and maintain CMM programs for critical SMT and mechanical parts using Zeiss or equivalent systems.
• Establish inspection plans and work instructions for incoming and supplier parts.
• Perform first article inspection (FAI) and dimensional validation.
• Act as subject matter expert in GD&T / ISO 8015, including training of technicians and suppliers.
• Manage calibration of measurement equipment and advance planning for NPI requirements.

Supplier Quality & Qualification

• Manage Supplier Part Qualification Process (SPQP) for new and existing suppliers.
• Perform supplier audits (process audit, pilot production audit, source inspection).
• Review supplier documentation including: FAI reports, Control Plans, FMEA, CPK / MSA studies, material and treatment certificates.
• Monitor supplier performance (DPPM, acceptance rate, first-pass yield).

Complaint & Failure Management

• Lead complaint management activities including such Preliminary failure analysis Containment and disposition coordination RTV arrangement and 8D follow-up, Apply structured problem-solving tools (5 Whys, 1H).
• Drive corrective and preventive actions to avoid recurrence.

Internal Quality & Team Support

• Support and guide IQA technicians to ensure adherence to SOPs.
• Balance inspection workload and improve inspection turnaround time.
• Participate in Material Review Board (MRB) activities.
• Maintain 6S and compliance with internal quality audits.

Requirements:

• Degree in Mechanical or Mechatronics Engineering, or a related field.
• Diploma holders with relevant experience may also be considered.
• Minimum 3–5 years of relevant experience in supplier quality or metrology function.
• Hands-on experience in CMM programming and inspection.
• Experience working with suppliers for machining, sheet metal, plastics, moulding, or SMT preferred.
• Well versed in CMM programming.
• Possess strong metrology knowledge